HAEWATCH2K Watch Hidden Camera User Manual

General Operation

Charging: Unscrew the USB Crown and insert the supplied USB cable then connect the other end to a DC 5V USB Power adapter. A blue LED will flash while the device is charging and turn solid blue once fully charged. Prior to first use please ignore the LED indicator and charge uninterrupted for 4 hours. When the battery is too low the blue LED will flash several times and power off.

Recordings Time & Date Stamp: Insert the USB cable into the USB Crown and the other end into a USB port on a personal computer or laptop. A new removable disk will appear on the screen. Open the removable disk and run the setup file. This will allow you to set the date and time stamp, frame size and video quality etc. Apply changes, select “Create configuration file” and “Exit”.

Setting the Watch Time: Pull out the Time Adjust Crown. Turn the crown to set the time. Push the crown back to the normal position once the time has been set.

Powering On/Off: Press and hold the Function Button. If the device has been left in standby mode for 2 minutes the device will automatically power off.

Video Mode: Once the device is powered on a green LED will flash several times and start the video recording automatically. Push the Function Button to pause the recording. The LED will turn solid blue to indicate it is in Standby Mode. Pushing the Function Button again will start another recording. The green LED will flash several times and go out to indicate it is recording.

Photograph Mode: From Standby Mode (solid blue LED) press the Function Button twice. An alternating blue and green LED will flash. To take a photo click the Function Button once. A blue LED will flash twice each time a photo is taken. To exit the photograph mode, press the Function Button twice. You should now be in Standby Mode (solid blue LED)

Audio Only Mode: From Standby Mode (solid blue LED) press the Function Button three times quickly. The blue LED will flash several times and go out. Audio is now being recorded. To exit the audio mode, press the Function Button once. You should now be in Standby Mode (solid blue LED)

Motion Detection Mode: From Standby Mode (solid blue LED) press the Function Button four times quickly. The green LED will flash. Video recording will start when motion is detected, and the green LED will flash faster. To pause press the Function Button once. A green solid LED will be displayed. Press the Function Button again to restart Motion Detection. To exit Motion Detection mode, press the Function Button four times quickly. You should now be in Standby Mode (solid blue LED)

Playback Recordings: Insert the USB cable into the USB Crown and the other end into a USB port on a personal computer or laptop. A new removable disk will appear on the screen. Open the removable disk and then select the Audio, Photo or Video Folder for the relevant recordings you wish to playback.  

Internal Memory: The internal memory is 16gb and must be formatted as FAT32. When the memory is full the oldest recordings will be over written (depending on the recording mode). If the memory cannot be automatically be overwritten both the blue and green LED will flash several times and power off.

Reset to Factory Defaults: Should the device become unstable please try resetting the device to Factory defaults. Press both the “Reset” and “Function” buttons at the same time.